All about sybex

Headlines on sybex

GNS3/dynamips/dynagen: configuration maker

Mon, 26 May 2008 15:08:31 +0000
Már egyszer írtam az itt található konfiguráció gyártó perl script-ről, most be is szeretném mutatni GNS3-al a működését.
A fenti linken jól le van írva, hogy a scriptet hogy kell használni. Nézzük tehát:
Először is rakjuk fel a scriptet egy olyan szerverre, vagy gépre ahol van perl. Nekem nem volt kedvem a windows-ra telepíteni, ezért a szerverünkre ...]

IEWB-DYN Lab 5 - BGP Highlights

Sun, 17 Feb 2008 14:34:17 +0000
Again, nothing too tricky on the BGP section (this is a lab rated 6!), quite a few peerings to configure. I actually missed on of these (R3 to SW2) out on my first pass of the question, but good job that I checked it and corrected my mistake.
AS-Path Manipulation
This scenario had a number of private ...]

New design at bkenny.com

Mon, 26 May 2008 10:50:22 +0000
I have finally managed to get my fingure out and start building a user friendly site.
I have installed the theme created by the guys over at www.designdisease.com
The next step is to get all the photos etc up on the site and adding more content, so keep your eyes peeled!

CCM Security - MGCP

Thu, 07 Sep 2006 07:04:15 +0000
crypto isakmp policy 1
encr 3des
authentication pre-share
group 2
lifetime 10800
crypto isakmp key cisco address 10.1.1.1
crypto isakmp key cisco address 10.1.1.2
!
!
crypto ipsec transform-set CM esp-3des esp-sha-hmac
mode transport
!
crypto map CM 1 ipsec-isakmp
set peer 10.1.1.1
set transform-set CM
match address 101
crypto map CM 2 ipsec-isakmp
set peer 10.1.1.2
set transform-set CM
match address 102
!
access-list 101 permit ip host 10.2.2.2 host 10.1.1.1
access-list 102 permit ip host ...]

How to prepend digits to called id in MGCP

Thu, 20 Jul 2006 02:15:00 +0000
Based on the ISDN number plan and type of the incoming call, the following values will be used to prepend the Caller ID.
National number prefix
International number prefix
Subscriber number prefix
Unknown number prefix

offer] How To Use Switches In Dynamips, use all commands, not just vlan database

Thu, 12 Jun 2008 05:19:48 +0000
All users of dynamips must have figured out by now that you can use NM16-ESW module for using switching commands on router, however, those are really restricted only to vlan database mode, however, not so now

If I Were The Blog Catalog Administrator……

Fri, 18 Apr 2008 21:45:34 +0000
Since long, I have been watching the steep hike in the membership of senior citizens at B.C compared to the increase of the fresh, new and exuberant younger lot. The seniors are, of course there to look up to but I think I’ve got a bit too tired of them now! The “oldies” as I ...]

Arriving to conclusions can be considered the most difficult part of any form of writing. We felt the same here with this article on sybex. Hope you enjoyed it.
#



Recommended sybex Items



Great New Deals


350 001
640 801
642 801
ccie lab scenario